Microcom 412 Manuel de l'opérateur télécharger pdf (Page 96)

Printer Commands Chapter 5

5-30 428TC Operator’s Manual - 880041-0141

address in not reachable on your network, you will need to change the IP address to one

that matches your network. One way would be to use the Device Installer software from

Lantronix (Refer to Chapter 3) to setup the port or you may use the Telnet Pass through

mode.

^A ^D COMMAND

171 Telnet Pass-Through Mode

To use the Telnet mode on the printer, the unit must be configured for

Ethernet use (^A1^D108) and then booted into the diagnostics mode by

turning the printer on with the print button pressed and held in. Once the

printer boots, it will start to feed media and the button may be released. The

printer auto detects the active RS232 Serial port or USB port when booting

into diagnostics mode regardless of its current port setting. Once

communication has been established, the ^D171 command may be

issued to access the XPORT setup parameters.

By selecting 0 Server, you may enter your IP address, Gateway, Net Mask,

and Telnet password.

IP Address

The IP address must be set to a unique value in your network. Default is set

to 192.168.200.3

Set Gateway IP Address

The gateway address, or router, allows communication to other LAN

segments. The gateway address should be the IP address of the router

connected to the same LAN segment as the unit. The gateway address must

be within the local network. The default is N (No), meaning the gateway

address has not been set. To set the gateway address, type Y and enter the

address.

Netmask: Number of Bits for Host Part

A netmask defines the number of bits taken from the IP address that are

assigned for the host section.

The unit prompts for the number of host bits to be entered, then calculates the

Change Setup:

0 Server

1 Channel 1

3 E-mails

5 Experts

6 Security

7 Factory defaults

8 Exit without save

9 Save and exit Your choice?

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 238 239

Pas de commentaire

Microcom 412 Manuel de l'opérateur Page 96