Microcom 412 Manuel de l'opérateur télécharger pdf (Page 82)

Printer Commands Chapter 5

5-16 428TC Operator’s Manual - 880041-0141

3 Response After Print: If enabled, an enquiry response will be sent

through the communications after every print automatically.

1 = Enable

0 = Disable

4 INPUT 2 Active State: This bit determines whether the INPUT 2 sensor

must see an object or not to send back the >INPUT 2< response. A

setting of 1 (active LOW) will report the >INPUT 2< message if no

reflection is detected. A setting of 0 (active HIGH) will report the

>INPUT 2< message if a reflection is detected.

1 = Send >INPUT 2< active LOW

0 = Send >INPUT 2< active HIGH

5 Accept “|” for Ctrl: Sets whether the “pipe” character will be

interpreted the same as the “Ctrl” key. The “pipe” character is the

<SHIFT> + \ key.

1 = Disable

0 = Enable (<|> key functions as <Ctrl> key)

6 Accept “^” for Ctrl: Sets whether the “caret” character will be

interpreted the same as the “Ctrl” key. The “caret” character is the

<SHIFT> + 6 key.

1 = Disable

0 = Enable (^ key functions as <Ctrl> key)

7 Binary Compression: If enabled, the printer will accept downloaded

binary compressed font and/or graphic files. The ^E command will not

function. (See 5.1)

1 = Enable Binary Mode

0 = Disable Binary Mode

8 Detect Black Line on Power-up: If enabled, the printer automatically

feeds labels on Power-up to determine the proper ^D90 value.

1 = Enable

0 = Disable

5.2.1.4 Software Switch #4

^AB ^D COMMAND

XX 24 Change SW4: Software Switch #4.

^AB12345678 (each bit is represented by a numeric position number)

Position:

1 Slashed Zeros: If enabled, the printer will print a slash through the

embedded zero (“0”) characters.

1 = Enable

0 = Disable

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 238 239

Pas de commentaire

Microcom 412 Manuel de l'opérateur Page 82