Microcom 412 Manuel de l'opérateur télécharger pdf (Page 80)

Printer Commands Chapter 5

5-14 428TC Operator’s Manual - 880041-0141

0 = Accept Incoming Control Codes

4 Port #1 Parity Selection: Sets the printer port #1 parity for serial

communication.

1 = Odd Parity

0 = Even Parity

5 Port #1 Parity Enable: Turns printer port #1 parity ON or OFF for serial

communication.

1 = Disable Parity (NONE)

0 = Enable Parity

6 Echo: If this feature is enabled, the printer will echo all received

characters to the serial port.

1 = Enable

0 = Disable

7 Number of Data Bits: Sets the printer’s serial port to use either 7 or 8

data bits.

1 = 8 Data Bits

0 = 7 Data Bits

8 XON/XOFF Flow Control: Sets software flow control handshaking.

CTS/RTS hardware handshaking is always enabled.

1 = Enable

0 = Disable

5.2.1.2 Software Switch #2

^AB ^D COMMAND

XX 22 Change SW2: Software Switch #2.

^AB12345678 (each bit is represented by a numeric position number)

Position:

1 Clear Text Function: If enabled, all variable text strings will be erased

when the ^D<CR> is processed.

1= Enable

0 = Disable

2 >RESTARTED< Response: If the printer has been reset and this

switch has been enabled, the printer will respond with the

>RESTARTED< message for the first enquiry ONLY, to denote the

reset condition and then >READY< with following enquiries.

1 = Enable (>RESTARTED< on first inquiry then >READY<)

0 = Disable (Always responds with >READY<)

3 Button Use: If set to a “1”, the printer will disable the Print Button.

1 = Disable

0 = Enable

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 238 239

Pas de commentaire

Microcom 412 Manuel de l'opérateur Page 80