Microcom 412 Manuel de l'opérateur télécharger pdf (Page 115)

Chapter 5 Printer Commands

428TC Operator’s Manual - 880041-0141 5-49

The following is an example of the ^D61, ^D63, and ^D64 commands:

^A0^D64<CR> (Clears any old settings)

^D57<CR>

6,1280,900,,38,7,0,1,385,0,0 <CR>

1,300,300,20,1,4<CR>

2,300,250,20,1,4<CR>

3,300,200,20,1,4<CR>

4,300,150,20,1,4<CR>

5,300,100,20,1,4<CR>

6,300,50,20,1,4<CR>

^D56 <CR>

^D2 <CR>

Protected Field<CR>

Variable Field<CR>

^A3^D63<CR> (Enables Auto-Print and Clears text)

^A3^D64<CR> (Instructs printer to print after 3 <CR>)

^A3^D61<CR> (Instructs printer to start text entry at line 3 instead

of line 1)

5.9 Cutter Configuration Commands

5.9.1 Cutter Type

The ^D115 is a non-volatile command that sets the proper type of cutter installed on the

printer being used. This value is reported to the ^D29 statistics label. This command

should be used prior to enabling the cutter with the ^D99 or ^D111 commands.

^A ^D Command

X 115 Set Cutter Type

0 No Cutter

1 Guillotine

2 Rotary

5.9.2 Kiosk Cutter Commands

5.9.2.1 Kiosk Cutter Mode

This is a non-volatile command that enables cutter operation. When a printer is configured

to use the ^D111, the printer prints a job, dispenses the advance distance (See ^D112), and

then cuts the media. The media is not retract until the next format which helps to prevent

paper jams going into the cutter or media wrapping around the platen roller. Modes 2 and 4

use the optional LTS sensor. When using these modes, a second form will not print until the

label is taken. The printer will report the >TAKE LABEL< message when the LTS detects

media and then only >READY< when the form is taken.

XX 111 Kiosk Cutter Mode

0 Disable Kiosk Cutter Mode.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 238 239

Pas de commentaire

Microcom 412 Manuel de l'opérateur Page 115