Microcom 412 Manuel de l'opérateur télécharger pdf (Page 106)

Printer Commands Chapter 5

5-40 428TC Operator’s Manual - 880041-0141

When using media that contains a blow-hole, set software switch #4 (^D24 command) for

blow-hole detection and then issue the desired auto-size command before issuing the auto-

size command or the results may be invalid.

^A ^D COMMAND

X 39 Auto-size:

0 Clears the use of auto-size values set by issuing the ^A1^D39<CR>.

1 Uses the values obtained for header variables instead of what is specified in

the format file’s header.

2 Automatically sizes the label and displays to the terminal screen the values for

the format header.

3 39 Same as ^A2^D39<CR>, but the values will be printed on the media.

5 Diagnostic Mode that steps the motor while displaying the readings from the

printers sensors to determine the media’s proper ^D90 and ^D91 settings.

This is also referred to as “tick-tick” mode.

6 Diagnostic Mode that does not step the motor while displaying the readings

from the printers sensors to determine the media’s proper ^D90 and ^D91

settings. When using this mode, the media is manually moved through the

printer. This is also referred to as “silent tick-tick” mode.

5.4.8 AutoHeader Commands

^A ^D COMMAND

X 147 Autoheader Command: The STL Autoheader command provides similar

functionality of other printer manufacturers that specify exact placement and

location of blackline media used for registration. This command is a specialty

media handling command that works when the correct media is used. Please

contact your Microcom Corporation representative if you have any questions

regarding the use of this command. When enabled the printer will autoload

and determine the correct header parameters for all subsequent formats

based on the loaded media except for HFM which is the only parameter that

must be included with the format header. The above values may be changed

via the appropriate ^D command with the change being permanent until

another Autoheader or another ^D command changes them.

After executing the Auto-header command, the values that the printer will use

for the header may be observed using the ^D148 command.

When stock is initially loaded the printer will do an auto header to determine

the correct header parameters. After this, when stock is loaded, the printer will

just advance the stock to the correct printing position wasting the first label

unless stock is loaded after a stock out condition. Then the printer will pull the

stock in and print on the first label and clear the error.

0 147 Execute AutoHeader on power-up only.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 238 239

Pas de commentaire

Microcom 412 Manuel de l'opérateur Page 106