Microcom 814M Programming Manual Manuel d'utilisateur télécharger pdf (Page 24)

ESC = n

[Name]

[Format]

[Range]

[Description]

[Notes]

[Default]

Set peripheral device

ASCII ESC = n

Hex 1B 3D n

Decimal 27 61 n

0 ≤ n ≤ 255

Disable or enable peripheral device to which host computer sends data.

• The lowest bit of n is effective;

• When the LSB of n is 0, printer is disabled;

• When the LSB of n is 1, printer is enabled’

• When the printer is enabled when power on

When the printer is disabled, it ignores all data except for real-time command (DLE

EOT) until it is enabled by this command.

N = 1

ESC ? n

[Name]

[Format]

[Range]

[Description]

[Notes]

[Reference]

Cancel user-defined characters

ASCII ESC ? n

Hex 1B 3F n

Decimal 27 63 n

32 ≤ n ≤ 127

Cancels user-defined characters.

 This command cancels the pattern defined for the character code specified by n. After

the user-defined characters are canceled, the corresponding pattern for the internal

character is printed.

 If a user-defined character has not been defined for the specified character code, the

printer ignores this command.

 ESC &, ESC %

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 101 102

Pas de commentaire

Microcom 814M Programming Manual Manuel d'utilisateur Page 24