Microcom 400 Manuel de l'opérateur télécharger pdf (Page 15)

400 Operators Manual

CHAPTER 2: BASIC OPERATION

2.1 UNPACKING THE 400 PRINTER

While unpacking the printer, please check all packing materials closely to avoid misplacing any

necessary parts. After the printer is removed from the box, verify that all parts are present and

in good condition (see Figure 3). All packaging material should be kept and used if the printer

is to be shipped.

Printer Parts

Figure 3

2.2 INSTALLING LABEL SUPPLY RACKS

To install the supply racks, simply place the printer on its face so that the rear panel is facing

up. Locate and remove the lower two screws and mount the lower side of the left and right

racks. Once the lower sides are secured, mount the upper sides in the same manner.

2.3 INSTALLING OPTIONAL SUPPLY COVER

Supply Cover

Figure 4

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 99 100

Pas de commentaire

Microcom 400 Manuel de l'opérateur Page 15