Microcom 438 Manuel d'utilisateur télécharger pdf (Page 116)

Chapter 7 Downloadable Fonts

438 Operator’s Manual - 880052-0100 7-7

7.6 Downloadable Font Command Summary

The following commands refer to the use of downloadable fonts and graphics:

^A ^D COMMAND

100 Clear User RAM: This command clears all downloadable fonts, graphics, and

stored label formats.

101 List Memory Bytes Available: The printer will send the “>” character

followed by the amount of available bytes and then finally a “<” character

(>192690<).

XX 104 Load GRAPHIC or FONT into RAM Memory without Compression:

The ^Axx specifies which memory slot to place the image/font (1-255). This

command should be used with an ASCII-HEX file that contains only printable

characters less than 80 HEX. This command supports GRAPHICS over

64KB.

XX 106 Load GRAPHIC or FONT into RAM Memory without Compression:

This command is intended for legacy support only and Microcom Corporation

recommends either the ^D104 or ^D107 commands.

Fonts must be less than 64KB for this command to function.

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 213 214

Pas de commentaire

Microcom 438 Manuel d'utilisateur Page 116