Microcom 428TM Manuel de l'opérateur télécharger pdf (Page 140)

Downloadable Graphics Chapter 6

6-8 428TM Operator’s Manual - 880042-0141

6.7 Downloadable Graphics Commands

The following commands refer to the use of downloadable graphics:

^A ^D COMMAND

100 Clear User RAM: This command clears all downloadable fonts, graphics, and

stored label formats.

101 List RAM Memory Bytes Available: The printer will send the “>” character

followed by the amount of available bytes and then finally a “<” character. (i.e.

>192690<)

XX 104 Save GRAPHICs or FONTs into RAM Memory without Compression:

The ^Axx specifies which memory slot to place the image/font (1-255). This

command should be used with an ASCII-HEX file that contains only printable

characters less than 80 HEX. This command supports graphics over 64KB.

XX 105 Delete Graphics from RAM:

0 Deletes ALL graphics from RAM

XX Deletes the graphics in slot #XX

XX 106 Save GRAPHICs or FONTs into RAM Memory without Compression:

This command is intended for legacy support only and Microcom Corporation

recommends either the ^D104 or ^D107 commands. Fonts must be less than

64KB for this command to function.

XX 107 Save GRAPHICs or FONTs into RAM Memory using Binary Compression:

XX 133 Save Compressed GRAPHIC to FLASH.

1 2 ... 135 136 137 138 139 140 141 142 143 144 145 ... 242 243

Pas de commentaire

Microcom 428TM Manuel de l'opérateur Page 140